Legally sound certification:
Free Claim CheckFoodservice and single-use tableware
A paper cup is rarely just paper. The coating helps decide how it is classified. Under the 95/5 rule of the PPWR, packaging with no more than 5 per cent insignificant other material does not count as composite packaging. Food contact packaging is also subject to PFAS limits.

The Single-Use Plastics Directive sets no general minimum share of plastic. Paper cups with a thin plastic coating can also be covered as single-use plastic products. What matters are the materials used and the specific product structure. The 95/5 rule of the PPWR does not create an exemption from the Single-Use Plastics Directive.
We evaluated six literature sources on the usual application ranges for polymeric additives in paper technology and derived a mean of 0.93 per cent. The figure is not a legal reading but a technical bearing: it shows the order of magnitude in which additives occur in paper anyway, and therefore how tightly a threshold can be set without capturing conventional paper along with it.
Since 12 August 2026 food contact packaging may not be placed on the market if it reaches or exceeds any of these values: 25 ppb for individual PFAS under targeted analysis, 250 ppb for the sum of PFAS determined by targeted analysis, in both cases excluding polymeric PFAS from quantification, and 50 ppm for PFAS including polymeric PFAS.
The distinction from total fluorine matters. Where total fluorine exceeds 50 mg/kg, it must be possible on request to show which share of the measured fluorine is PFAS and which is not. What counts is the packaging when it is first placed on the market. For service packaging such as typical takeaway cups, this generally happens in the unfilled state.
Not on its own. The Commission PPWR guidance makes clear that the manufacturer under the regulation is whoever places packaging on the market under their own name or brand. Within a supply chain there is in principle only one. Suppliers must provide information and documents, but responsibility for conformity assessment and technical documentation stays with the party placing the product on the market.
A mill-side certification of your input material is therefore a valuable building block, not a substitute. The sub-licence system exists for exactly this case: an existing certification can, under defined conditions, be transferred to the brand and its specific product without rebuilding the chain.
From that date the Empowering Consumers for the Green Transition Directive applies. Sustainability labels may then in principle only be used where they rest on a certification scheme or were established by a public authority. Generic environmental claims without recognised excellent performance are prohibited.
This is not only about words. Your own green logo on the cup can count as an environmental claim or a sustainability label too. Since 27 September 2026, own sustainability labels in principle require a corresponding certification scheme unless they were established by a public authority. Specific, substantiated environmental claims, by contrast, do not automatically need certification.
Certificates from this sector
The running certificates are verifiable with licence number, assessment basis and validity in the public certification database




















The next step
Every certification starts with the same question: what exactly is to be claimed. The trustmark page sets out what the scheme assesses, what it rests on and how the process runs.
